Page tree
Skip to end of metadata
Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 9 Next »

live-template: Template named 'null' is not accessible.

The results reported for individual stages of a staged construction load case are cumulative results (for example, results for stage 2 contain contribution from both stages 1 and 2). If you need to obtain only response due to the loading applied in a particular stage, you could use one of the following approaches:

  • Post-process SAP2000 results. To obtain results for stage n, subtract results for stage (n-1) from results for stage n.
  • Redefine the single staged construction load case as a chained sequence of load cases, each using stiffness at the end of the previous case. Then setup a load combination to obtain results only for a given stage n as follows:
    • results for stage n only = (cumulative results for stage n) - (cumulative results for stage (n-1))

The second approach is illustrated in the attached as shown on the screenshots below:

The model is a horizontal cantilever with point load in gravity direction applied to the free end:

In a staged construction load case STAGED, incremental loads of 1kN, 10kN and 100kN are applied in stages 1, 2 and 3:

To obtain noncumulative results only for stages 2 and 3, setup a single-stage staged construction load cases "STAGED stage 1", "STAGED stage 2", and "STAGED stage 3" that are equivalent to the STAGED construction load case, but the loading is represented as a chained sequence of separate load cases rather than a single load case.

Then setup load combinations "stage 1 only", "stage 2 only" and "stage 3 only" as described above to obtain noncumulative results for each stage. The figure below shows that results are as expected:


  • No labels