General Topics   SAP2000   CSiBridge   ETABS   SAFE   PERFORM-3D   CSiCOL   Tutorials   Test Problems   Documentation   Licensing
##### Page tree
Go to start of banner

You are viewing an old version of this page. View the current version.

Version 23

live-template: Template named 'null' is not accessible.

This test problem explains and demonstrates the application of temperature gradient to bridge objects. To summarize the process, temperature gradient is specified and applied to the transformed section, axial force (P) and moment (M3) are calculated, then an equivalent constant + linear temperature distribution is applied over the depth.

This process enables the correct calculation of overall cross-sectional force and moment. Nodal application of actual temperatures induced by the temperature distribution specified would yield incorrect net fore and moment without the cross section being finely discretized.

# Procedure

The stress distribution of a temperature gradient is calculated as E α T. Users may analytically solve for axial force (P) by integrating this expression over the section, accounting for the web and flange areas. To solve for M3, integrate the moment of stresses about the neutral axis.

CSI

Software derives temperature-gradient response by following these formulations. First, the software assumes a linear gradient with two unknowns, including neutral-axis value and gradient slope. Integration procedures yield a set of polynomial expression for P and M3. Simultaneous solution then yields exact expressions for axial force and moment.

# Examples

The following two examples demonstrate temperature-gradient application. Screen shots and attached hand calculations illustrate the procedure.

## Example 1 - Bridge-modeler model

A single-span concrete-box bridge, fixed at both abutments, is created using the bridge modeler. The linked bridge object is updated as a solid model. Loading from temperature gradient is defined as shown in Figure 1:

Unknown macro: {center-text}

As mentioned earlier, an equivalent constant + linear temperature gradient generates the temperature load for a solid model. This procedure correlates precisely with the attached hand calculations , as shown in Figure 2:

Unknown macro: {center-text}

For bridge response, loading from the temperature gradient induces a moment of 2568 kip-ft, which closely correlates with the hand calculated moment of 2669 kip-ft. Software output is shown in Figure 3:

Unknown macro: {center-text}

Figure 3 - Moment induced by temperature gradient