Page tree
Skip to end of metadata
Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 23 Next »

Test Problem

Name:

Align solid and hollow sections with different center-of-gravity locations

Description:

Model relative positive position for frame sections which have identical outlines, but different center-of-gravity locations due to one section being hollow.

Program:

SAP2000

Version:

14.2.0

Model ID:

na


The internal forces and capacities of a beam are calculated with respect to the cross-section center of gravity. This test problem studies the modeling of a rectangular and continuous beam which is solid along the left segment and hollow along the right. This void is located along the bottom of the element.

Default insertion-point settings locate each segment such that the center of gravity aligns with the element chord. As shown in the image at the top of Figures 1-4, this results in misalignment between each segment because the center of gravity is higher for the hollow section. This may be corrected through either of the following methods:

  1. Draw element chords to account for the difference in center-of-gravity location, as shown in the middle image of each figure.

  2. Use a bottom-center insertion point to draw the two segments along the same line as shown in the bottom image of each figure.




To demonstrate how each of these conditions affects response, a straight tendon is modeled below each beam. Tendon deflection and internal moment (relative to cross-section centroid) is presented. Results are correctly reported only for the second and third case, where the solid and hollow sections properly align.



Attachments

  • No labels