Page tree
Skip to end of metadata
Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 9 Current »

 

SAP2000 calculates section-cut forces by summing the forces which act on member joints within the group of frame, shell, and link objects which define the section cut. During summation, the forces and moments at joint locations are transformed into equivalent conditions at a point of summation. They are then transformed into the local coordinate system which is specified for the reporting of section-cut forces. Section cuts may be defined by group, by cutting plane, or within the graphical user interface.

Articles

Tutorials

TitleDescriptionProgram

Section-cut first steps

Introductory tutorial for using section cuts.

SAP2000

Test Problems

TitleDescriptionProgram

Frame and shell section cuts

Section cuts are defined through a simply-supported beam which is modeled using frame and shell objects.

SAP2000

Moving-load analysis section cuts

Verification of section-cut forces generated during moving-load analysis.

SAP2000

Saving section cuts during moving-load analysis

Sections cuts may be saved during moving-load analysis through this procedure.

SAP2000

Section cuts drawn within the graphical user interface

Draw section cuts within the graphical user interface using either 2D or 3D views.

SAP2000

Tendon force vs. frame response

Tendon application is validated by comparing tendon forces to those in an equivalent frame system.

SAP2000

  • No labels