Page tree
Skip to end of metadata
Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 2 Next »



Influence-based moving-load analysis first steps (CSiBridge)


Procedure for setting up influence-based moving-load analysis.





Model ID:


Influence-based moving-load analysis can be setup using the following procedure:

  • Define Vehicle through "Loads Tab > Vehicles > New"
  • Define vehicle class through "Loads Tab > Vehicle Classes > New". Note that default vehicle class is automatically added for each vehicle.
  • Define layout line via "Layout Tab > Layout Line > New"
  • Define lane via "Layout Tab > Lane > New"
  • Define a moving-load case via "Analysis Tab > Load Cases > New". Set the load-case type to Moving Load, then specify the vehicles and lanes assigned to this moving load, as shown in Figure 1:


Figure 1: Moving load case definition



See Also

  • No labels